Hard and tough resin 705B
Name: shoe material hard and tough 3D printing photosensitive resin
Model: 705B
Color: pink
Package: Barrel
Specifications: 5 kg / 10 kg / 20 kg
3D printing Hard and tough UV resin
Product details:
Name: shoe material hard and tough 3D printing photosensitive resin
Model: 705B
Color: pink
Package: Barrel
Specifications: 5 kg / 10 kg / 20 kg
Introduction:
shoe material, temperature resistance in general, can be tapped, specifically for shoe material class photosensitive resin, can be made into durable, tough and waterproof functional parts.
Applicable printers:
Applicable to industrial grade SLA 3D printers with a wavelength of 355nm.
Applications:
It is applied to print, durable, waterproof and low shrinkage engineering parts, which can be used to produce shoe materials, aerospace parts, concept models, small production parts, etc.
Material property data
PROPERTY | Unit | PROCEDURE | Results |
Viscosity | （cps@25℃） | 280-360 | |
Critical exposure energy | ( mJ/cm2 ) | 10.1~13 | |
Tensile Strength | MPa | ASTM D638 | 38-56 |
Tensile modulus | MPa | ASTM D638 | 2,591-2,696 |
Breaking elongation rate | % | ASTM D638 | 8-12 |
Notched impact strength | J/m | ASTM D256 | 33-38 |
Heat distortion temperature | ℃ | ASTM D 648 @66PSI | 38-50 |
Shore hardness | D | 79 |
Notice：
The above values may vary depending on the geometry of the part, printing settings, temperature changes, secondary post-curing, etc. The actual values may vary. Therefore, users must test the product before use to ensure that it can meet your final use of printing performance. Require. The above values are typical values and we do not agree with them as binding material specifications or warranties unless expressly agreed in writing. The final effect depends on the actual usage of the user, this table is for reference only.
instructions
l Caution.
l Shake well before use before pouring into the resin tank.
l This resin cannot be mixed with other resins, liquids, substances, etc., otherwise it will cause printing failure.
l Lower temperature may affect the printing effect, and the resin can be properly preheated before use (not more than 35℃).
l taking care to wear protective gloves and masks and to keep the room ventilated during use.
l this product contains active chemicals, this product avoid contact with eyes, skin and clothing.
l This product is slightly irritating to eyes and skin, if contact with eyes is accidental, please rinse immediately with plenty of water and seek medical attention.
l Please rinse with soap and water immediately after contact with the skin; wash thoroughly after contact with clothing before wearing.
l Avoid contact with children and pregnant women.
Storage and transportation
l Storage and transportation.
l Resin should be stored and transported in its original packaging in a sealed and light-proof environment, avoiding high temperatures and sunlight.
l Recommended storage temperature is 18-35°C.
l Do not mix and store resin left in the resin tank with unused resin after printing. It should be stored in a separate light-proof container.
l For safety information, please refer to the MSDS of this product. if you encounter any problems during use, please feel free to contact us.
